NT5CB128M8DN View Datasheet(PDF) - Nanya Technology

Part Name

Description

Manufacturer

NT5CB128M8DN

1Gb DDR3 D-die SDRAM

Nanya Technology 

NT5CB128M8DN/NT5CB64M16DP

NT5CC128M8DN/NT5CC64M16DP

1Gb DDR3 D-die SDRAM

Basic Functionality

The DDR3/L SDRAM D-Die is a high-speed dynamic random access memory internally configured as an eight-bank

DRAM. The DDR3/L SDRAM uses an 8n prefetch architecture to achieve high speed operation. The 8n prefetch

architecture is combined with an interface designed to transfer two data words per clock cycle at the I/O pins. A single

read or write operation for the DDR3/L SDRAM consists of a single 8n-bit wide, four clock data transfer at the internal

DRAM core and two corresponding n-bit wide, one-half clock cycle data transfers at the I/O pins.

Read and write operation to the DDR3/L SDRAM are burst oriented, start at a selected location, and continue for a burst

length of eight or a ‘chopped’ burst of four in a programmed sequence. Operation begins with the registration of an Active

command, which is then followed by a Read or Write command. The address bits registered coincident with the Active

command are used to select the bank and row to be activated (BA0-BA2 select the bank; A0-A13 select the row). The

address bit registered coincident with the Read or Write command are used to select the starting column location for the

burst operation, determine if the auto precharge command is to be issued (via A10), and select BC4 or BL8 mode ‘on the

fly’ (via A12) if enabled in the mode register.

Prior to normal operation, the DDR3/L SDRAM must be powered up and initialized in a predefined manner. The following

sections provide detailed information covering device reset and initialization, register definition, command descriptions

and device operation.

RESET and Initialization Procedure

Power-up Initialization sequence

The Following sequence is required for POWER UP and Initialization

1. Apply power (

is recommended to be maintained below 0.2 x VDD, all other inputs may be undefined).

needs to be maintained for minimum 200/s with stable power. CKE is pulled “Low” anytime before

being

de-asserted (min. time 10ns). The power voltage ramp time between 300mV to VDDmin must be no greater than 200ms;

and during the ramp, VDD>VDDQ and (VDD-VDDQ) <0.3 Volts.

- VDD and VDDQ are driven from a single power converter output, AND

- The voltage levels on all pins other than VDD, VDDQ, VSS, VSSQ must be less than or equal to VDDQ and VDD on one

side and must be larger than or equal to VSSQ and VSS on the other side. In addition, VTT is limited to 0.95V max once

power ramp is finished, AND

- Vref tracks VDDQ/2.

OR

- Apply VDD without any slope reversal before or at the same time as VDDQ.

- Apply VDDQ without any slope reversal before or at the same time as VTT & Vref.

- The voltage levels on all pins other than VDD, VDDQ, VSS, VSSQ must be less than or equal to VDDQ and VDD on one

side and must be larger than or equal to VSSQ and VSS on the other side.

REV 1.2

May. 2011

CONSUMER DRAM

© NANYA TECHNOLOGY CORP.

All rights reserved

NANYA TECHNOLOGY CORP. reserves the right to change Products and Specifications without notice.

Share Link: