NT5CB128M8DN-CFI View Datasheet(PDF) - Nanya Technology

Part Name

Description

Manufacturer

NT5CB128M8DN-CFI

1Gb DDR3 D-die SDRAM

Nanya Technology 

NT5CB128M8DN/NT5CB64M16DP

NT5CC128M8DN/NT5CC64M16DP

1Gb DDR3 D-die SDRAM

Multi-Purpose Register (MPR)

The Multi Purpose Register (MPR) function is used to Read out a predefined system timing calibration bit sequence. To

enable the MPR, a Mode Register Set (MRS) command must be issued to MR3 register with bit A2=1. Prior to issuing the

MRS command, all banks must be in the idle state (all banks precharged and tRP met). Once the MPR is enabled, any

subsequent RD or RDA commands will be redirected to the Multi Purpose Register. When the MPR is enabled, only RD or

RDA commands are allowed until a subsequent MRS command is issued with the MPR disabled (MR3 bit A2=0). Power

down mode, Self-Refresh and any other non-RD/RDA command is not allowed during MPR enable mode. The RESET

function is supported during MPR enable mode.

The Multi Purpose Register (MPR) function is used to Read out a predefined system timing calibration bit sequence.

Fig. 12: MPR Block Diagram

To enable the MPR, a MODE Register Set (MRS) command must be issued to MR3 Register with bit A2 = 1, as following

Table 1. Prior to issuing the MRS command, all banks must be in the idle state (all banks precharged and tRP met). Once

the MPR is enabled, any subsequent RD or RDA commands will be redirected to the Multi Purpose Register. The resulting

operation, when a RD or RDA command is issued, is defined by MR3 bits A[1:0] when the MPR is enabled as shown on

page28. When the MPR is enabled, only RD or RDA commands are allowed until a subsequent MRS command is issued

with the MPR disabled (MR3 bit A2 = 0). Note that in MPR mode RDA has the same functionality as a READ command

which means the auto precharge part of RDA is ignored. Power-Down mode, Self-Refresh and any other non-RD/RDA

command is not allowed during MPR enable mode. The RESET function is supported during MPR enable mode.

REV 1.2

May. 2011

CONSUMER DRAM

© NANYA TECHNOLOGY CORP.

All rights reserved

NANYA TECHNOLOGY CORP. reserves the right to change Products and Specifications without notice.

Share Link: