STM32F031C4(2015) View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STM32F031C4
(Rev.:2015)

ARM®-based 32-bit MCU with up to 32 Kbyte Flash, 9 timers, ADC and communication interfaces, 2.0 - 3.6 V

STMicroelectronics 

STM32F031x4 STM32F031x6

Functional overview

3.8

Direct memory access controller (DMA)

The 5-channel general-purpose DMAs manage memory-to-memory, peripheral-to-memory

and memory-to-peripheral transfers.

The DMA supports circular buffer management, removing the need for user code

intervention when the controller reaches the end of the buffer.

Each channel is connected to dedicated hardware DMA requests, with support for software

trigger on each channel. Configuration is made by software and transfer sizes between

source and destination are independent.

DMA can be used with the main peripherals: SPIx, I2Sx, I2Cx, USARTx, all TIMx timers

(except TIM14) and ADC.

3.9

3.9.1

3.9.2

Interrupts and events

Nested vectored interrupt controller (NVIC)

The STM32F0xx family embeds a nested vectored interrupt controller

32 maskable interrupt channels (not including the 16 interrupt lines of

Cabolretetxo®h-aMn0d)leanudp

to

4

priority levels.

• Closely coupled NVIC gives low latency interrupt processing

• Interrupt entry vector table address passed directly to the core

• Closely coupled NVIC core interface

• Allows early processing of interrupts

• Processing of late arriving higher priority interrupts

• Support for tail-chaining

• Processor state automatically saved

• Interrupt entry restored on interrupt exit with no instruction overhead

This hardware block provides flexible interrupt management features with minimal interrupt

latency.

Extended interrupt/event controller (EXTI)

The extended interrupt/event controller consists of 24 edge detector lines used to generate

interrupt/event requests and wake-up the system. Each line can be independently

configured to select the trigger event (rising edge, falling edge, both) and can be masked

independently. A pending register maintains the status of the interrupt requests. The EXTI

can detect an external line with a pulse width shorter than the internal clock period. Up to 39

GPIOs can be connected to the 16 external interrupt lines.

3.10

Analog-to-digital converter (ADC)

The 12-bit analog-to-digital converter has up to 16 external and 3 internal (temperature

sensor, voltage reference, VBAT voltage measurement) channels and performs conversions

in single-shot or scan modes. In scan mode, automatic conversion is performed on a

selected group of analog inputs.

The ADC can be served by the DMA controller.

DocID025743 Rev 4

15/106

22

Share Link: