TS4962MEIJT(2005) View Datasheet(PDF) - STMicroelectronics
Part Name
Description
Manufacturer
TS4962MEIJT Datasheet PDF : 32 Pages
| |||
TS4962M
5 Application Information
Application Information
5.1 Differential configuration principle
The TS4962M is a monolithic fully-differential input/output class D power amplifier. The
TS4962M also includes a common-mode feedback loop that controls the output bias value to
average it at VCC/2 for any DC common mode input voltage. This allows the device to always
have a maximum output voltage swing, and by consequence, maximize the output power.
Moreover, as the load is connected differentially compared to a single-ended topology, the
output is four times higher for the same power supply voltage.
The advantages of a full-differential amplifier are:
● High PSRR (Power Supply Rejection Ratio).
● High common mode noise rejection.
● Virtually zero pop without additional circuitry, giving an faster start-up time compared to
conventional single-ended input amplifiers.
● Easier interfacing with differential output audio DAC.
● No input coupling capacitors required thanks to common mode feedback loop.
The main disadvantage is:
● As the differential function is directly linked to external resistor mismatching, paying
particular attention to this mismatching is mandatory in order to obtain the best
performance from the amplifier.
5.2 Gain in typical application schematic
Typical differential applications are shown in Figure 1 on page 3.
In the flat region of the frequency-response curve (no input coupling capacitor effect), the
differential gain is expressed by the relation:
AVdiff
=
-O-----u---t--+----–-----O-----u----t--
In+ – In-
=
3----0---0--
Rin
with Rin expressed in kΩ. For the remainder of this chapter, AVdiff will be referred to as AV for
simplicity’s sake.
Due to the tolerance of the internal 150kΩ feedback resistor, the differential gain will be in the
range (no tolerance on Rin):
2----7---3--
Rin
≤
AVdiff ≤
-3---2---7--
Rin
21/32
Share Link: 