DSP56362 View Datasheet(PDF) - Freescale Semiconductor

Part Name

Description

Manufacturer

DSP56362

24-Bit Audio Digital Signal Processor

Freescale Semiconductor 

Signal Name

MODD/IRQD

RESET

Host Interface (HDI08)

Table 2-8 Interrupt and Mode Control (continued)

Type State during Reset

Signal Description

Input

Input

Mode Select D/External Interrupt Request D—MODD/IRQD is an

active-low Schmitt-trigger input, internally synchronized to the DSP clock.

MODD/IRQD selects the initial chip operating mode during hardware reset

and becomes a level-sensitive or negative-edge-triggered, maskable

interrupt request input during normal instruction processing. MODA,

MODB, MODC, and MODD select one of 16 initial chip operating modes,

latched into OMR when the RESET signal is deasserted. If IRQD is

asserted synchronous to CLKOUT, multiple processors can be

resynchronized using the WAIT instruction and asserting IRQD to exit the

wait state.

This input is 5 V tolerant.

Input

Input

Reset—RESET is an active-low, Schmitt-trigger input. When asserted,

the chip is placed in the reset state and the internal phase generator is

reset. The Schmitt-trigger input allows a slowly rising input (such as a

capacitor charging) to reset the chip reliably. If RESET is deasserted

synchronous to CLKOUT, exact start-up timing is guaranteed, allowing

multiple processors to start synchronously and operate together in

“lock-step.” When the RESET signal is deasserted, the initial chip

operating mode is latched from the MODA, MODB, MODC, and MODD

inputs. The RESET signal must be asserted during power up. A stable

EXTAL signal must be supplied while RESET is being asserted.

This input is 5 V tolerant.

2.7 Host Interface (HDI08)

The HDI08 provides a fast, 8-bit, parallel data port that may be connected directly to the host bus. The

HDI08 supports a variety of standard buses and can be directly connected to a number of industry standard

microcomputers, microprocessors, DSPs, and DMA hardware.

2.7.1 Host Port Configuration

Signal functions associated with the HDI08 vary according to the interface operating mode as determined

by the HDI08 port control register (HPCR). See 6.5.6 Host Port Control Register (HPCR) on

page Section 6-13 for detailed descriptions of this register and (See Host Interface (HDI08) on

page Section 6-1.) for descriptions of the other HDI08 configuration registers.

DSP56362 Technical Data, Rev. 4

Freescale Semiconductor

2-9

Share Link: