DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

MT41J128M View Datasheet(PDF) - Micron Technology

Part Name
Description
Manufacturer
MT41J128M
Micron
Micron Technology Micron
MT41J128M Datasheet PDF : 214 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
General Notes
1Gb: x4, x8, x16 DDR3 SDRAM
Functional Description
• The functionality and the timing specifications discussed in this data sheet are for the
DLL enable mode of operation (normal operation).
• Throughout this data sheet, various figures and text refer to DQs as “DQ.” DQ is to be
interpreted as any and all DQ collectively, unless specifically stated otherwise.
• The terms “DQS” and “CK” found throughout this data sheet are to be interpreted as
DQS, DQS# and CK, CK# respectively, unless specifically stated otherwise.
• Complete functionality may be described throughout the document; any page or dia-
gram may have been simplified to convey a topic and may not be inclusive of all re-
quirements.
• Any specific requirement takes precedence over a general statement.
• Any functionality not specifically stated is considered undefined, illegal, and not sup-
ported, and can result in unknown operation.
• Row addressing is denoted as A[n:0]. For example, 1Gb: n = 12 (x16); 1Gb: n = 13 (x4,
x8); 2Gb: n = 13 (x16) and 2Gb: n = 14 (x4, x8); 4Gb: n = 14 (x16); and 4Gb: n = 15 (x4,
x8).
• Dynamic ODT has a special use case: when DDR3 devices are architected for use in a
single rank memory array, the ODT ball can be wired HIGH rather than routed. Refer
to the Dynamic ODT Special Use Case section.
• A x16 device's DQ bus is comprised of two bytes. If only one of the bytes needs to be
used, use the lower byte for data transfers and terminate the upper byte as noted:
– Connect UDQS to ground via 1kΩ* resistor.
– Connect UDQS# to VDD via 1kΩ* resistor.
– Connect UDM to VDD via 1kΩ* resistor.
– Connect DQ[15:8] individually to either VSS, VDD, or VREF via 1kΩ resistors,* or float
DQ[15:8].
*If ODT is used, 1kΩ resistor should be changed to 4x that of the selected ODT.
PDF: 09005aef826aa906
1Gb_DDR3_SDRAM.pdf - Rev. L 03/13 EN
13
Micron Technology, Inc. reserves the right to change products or specifications without notice.
‹ 2006 Micron Technology, Inc. All rights reserved.

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]