S25FL127S(2005) View Datasheet(PDF) - Cypress Semiconductor
Part Name
Description
Manufacturer
S25FL127S Datasheet PDF : 131 Pages
| |||
S25FL127S
4.4 DC Characteristics
Applicable within operating ranges.
Table 4.3 DC Characteristics
Symbol
Parameter
Test Conditions
Min
VIL
VIH
VOL
VOH
ILI (Industrial)
ILO (Industrial)
Input Low Voltage
Input High Voltage
Output Low Voltage
Output High Voltage
Input Leakage Current
Output Leakage
Current
IOL = 1.6 mA, VCC = VCC min
IOH = –0.1 mA
VCC = VCC Max, VIN = 0 to VIL Max or VIH,
CS# = VIH
VCC = VCC Max, VIN = VIH or VIL
-0.5
0.7 x VCC
0.85 x VCC
ILI (Industrial Plus)
ILO (Industrial
Plus)
Input Leakage Current
Output Leakage
Current
VCC = VCC Max, VIN= 0 to VIL Max or VIH,
CS# = VIH
VCC = VCC Max, VIN = VIH or VIL
Serial @50 MHz
ICC1
Active Power Supply
Current (READ)
Serial @108 MHz
Quad @108 MHz
Outputs unconnected during read data
return (2)
Active Power Supply
ICC2
Current (Page
CS# = VCC
Program)
ICC3
Active Power Supply
Current (WRR)
CS# = VCC
ICC4
Active Power Supply
Current (SE)
CS# = VCC
ICC5
Active Power Supply
Current (BE)
CS# = VCC
ISB (Industrial)
ISB (Industrial
Plus)
IPOR
Standby Current
Standby Current
Power On Reset
Current
RESET#, CS# = VCC; SI, SCK = VCC or
VSS, Industrial Temp
RESET#, CS# = VCC; SI, SCK = VCC or
VSS, Industrial Plus Temp
RESET#, CS# = VCC; SI, SCK = VCC or
VSS
Notes:
1. Typical values are at TAI = 25°C and VCC = 3V.
2. Output switching current is not included.
Typ (1)
70
70
Max
0.2 x VCC
VCC + 0.4
0.15 x VCC
±2
±2
±4
±4
16
24
47
50
50
50
50
100
300
63
Unit
V
V
V
V
µA
µA
µA
µA
mA
mA
mA
mA
mA
µA
µA
mA
4.4.1
Active Power and Standby Power Modes
The device is enabled and in the Active Power mode when Chip Select (CS#) is Low. When CS# is high, the device is disabled, but
may still be in an Active Power mode until all program, erase, and write operations have completed. The device then goes into the
Standby Power mode, and power consumption drops to ISB.
Document Number: 001-98282 Rev. *F
Page 29 of 130
Share Link: 