IS43TR16640A(2016) View Datasheet(PDF) - Integrated Silicon Solution

Part Name

Description

Manufacturer

IS43TR16640A
(Rev.:2016)

128MX8, 64MX16 1Gb DDR3 SDRAM

Integrated Silicon Solution 

IS43/46TR16640A, IS43/46TR16640AL

IS43/46TR81280A, IS43/46TR81280AL

2.4.4 DLL-off Mode

DDR3 DLL-off mode is entered by setting MR1 bit A0 to “1”; this will disable the DLL for subsequent operations until A0 bit

set back to “0”. The MR1 A0 bit for DLL control can be switched either during initialization or later. The DLL-off Mode

operations listed below are an optional feature for DDR3. The maximum clock frequency for DLL-off Mode is specified by

the parameter tCKDLL_OFF. There is no minimum frequency limit besides the need to satisfy the refresh interval, tREFI.

Due to latency counter and timing restrictions, only one value of CAS Latency (CL) in MR0 and CAS Write Latency (CWL)

in MR2 are supported. The DLL-off mode is only required to support setting of both CL=6 and CWL=6. DLL-off mode will

affect the Read data Clock to Data Strobe relationship (tDQSCK) but not the data Strobe to Data relationship (tDQSQ,

tQH). Special attention is needed to line up Read data to controller time domain.

Comparing with DLL-on mode, where tDQSCK starts from the rising clock edge (AL+CL) cycles after the Read command,

the DLL-off mode tDQSCK starts (AL+CL-1) cycles after the read command. Another difference is that tDQSCK may not

be small compared to tCK (it might even be larger than tCK) and the difference between tDQSCKmin and tDQSCKmax is

significantly larger than in DLL-on mode. The timing relations on DLL-off mode READ operation have shown at the

following Timing Diagram (CL=6, BL=8)

T0

CK#

CK

T1

T2

T3

T4

T5

T6

T7

T8

T9

T10

Command

READ

NOP

NOP

NOP

NOP

NOP

NOP

NOP

NOP

NOP

NOP

Address

DQS,DQS#(DLL_on)

RL (DLL_on) = AL+CL =6 (CL=6,AL=0)

CL=6

DQ(DLL_on)

DQS,DQS#(DLL_off)

RL (DLL_off) = AL+(CL-1) = 5

tDQSCK(DLL_off)_min

DQ(DLL_off)

DQS,DQS#(DLL_off)

tDQSCK(DLL_off)_max

DQ(DLL_off)

Don’t Care

Note: The tDQSCK is used here for DQS, DQS, and DQ to have a simplified diagram; the DLL_off shift will affect both timings in the same way and the

skew between all DQ, DQS, and DQS# signals will still be tDQSQ.

Figure 2.4.4 DLL-off mode READ Timing Operation

Integrated Silicon Solution, Inc. – www.issi.com –

20

Rev. J

03/14/2016

Share Link: