DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

DSP56362 View Datasheet(PDF) - Freescale Semiconductor

Part Name
Description
Manufacturer
DSP56362
Freescale
Freescale Semiconductor Freescale
DSP56362 Datasheet PDF : 152 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
External Memory Expansion Port (Port A)
Table 2-4 Clock and PLL Signals (continued)
Signal Name Type State during Reset
Signal Description
PCAP
Input
PINIT/NMI Input
Input
Input
PLL Capacitor—PCAP is an input connecting an off-chip capacitor to the PLL
filter. Connect one capacitor terminal to PCAP and the other terminal to VCCP.
If the PLL is not used, PCAP may be tied to VCC, GND, or left floating.
PLL Initial/Non maskable Interrupt—During assertion of RESET, the value of
PINIT/NMI is written into the PLL Enable (PEN) bit of the PLL control register,
determining whether the PLL is enabled or disabled. After RESET deassertion
and during normal instruction processing, the PINIT/NMI Schmitt-trigger input
is a negative-edge-triggered non maskable interrupt (NMI) request internally
synchronized to CLKOUT.
PINIT/NMI cannot tolerate 5 V.
2.5 External Memory Expansion Port (Port A)
When the DSP56362 enters a low-power standby mode (stop or wait), it releases bus mastership and
tri-states the relevant port A signals: A0–A17, D0–D23, AA0/RAS0–AA3/RAS3, RD, WR, BB, CAS.
2.5.1 External Address Bus
Table 2-5 External Address Bus Signals
Signal Name
Type
State during Reset
Signal Description
A0–A17
Output
Tri-Stated
Address Bus—When the DSP is the bus master, A0–A17 are
active-high outputs that specify the address for external program and
data memory accesses. Otherwise, the signals are tri-stated. To
minimize power dissipation, A0–A17 do not change state when
external memory spaces are not being accessed.
2.5.2 External Data Bus
Table 2-6 External Data Bus Signals
Signal Name
Type
State during Reset
Signal Description
D0–D23
Input/Output
Tri-Stated
Data Bus—When the DSP is the bus master, D0–D23 are active-high,
bidirectional input/outputs that provide the bidirectional data bus for
external program and data memory accesses. Otherwise, D0–D23 are
tri-stated.
DSP56362 Technical Data, Rev. 4
Freescale Semiconductor
2-5

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]