M2V28S20TP View Datasheet(PDF) - Mitsumi

Part Name

Description

Manufacturer

M2V28S20TP

128M Synchronous DRAM

Mitsumi 

SDRAM (Rev. 1.0E)

Jun. '99

MITSUBISHI LSIs

M2V28S20TP-6,-7,-8

M2V28S30TP-6,-7,-7L,-8,-8L

M2V28S40TP-7,-7L,-8,-8L

128M Synchronous DRAM

(4-BANK x 8,388,608-WORD x 4-BIT)

(4-BANK x 4,194,304-WORD x 8-BIT)

(4-BANK x 2,097,152-WORD x 16-BIT)

OPERATIONAL DESCRIPTION

BANK ACTIVATE

The SDRAM has four independent banks. Each bank is activated by the ACT command with

the bank addresses (BA0,1). A row is indicated by the row addresses A0-11. The minimum activation

interval between one bank and the other bank is tRRD. Maximum 2 ACT commands are allowed within

tRC , although the number of banks which are active concurrently is not limited.

PRECHARGE

The PRE command deactivates the bank indicated by BA0,1. When multiple banks are active,

the precharge all command (PREA, PRE + A10=H) is available to deactivate them at the same time.

After tRP from the precharge, an ACT command to the same bank can be issued.

Bank Activation and Precharge All (BL=4, CL=3)

CLK

Command

A0-9

A10

2 ACT command / tRCmin

ACT

ACT READ

tRRD

Xa

Xb Y

tRCD

Xa

Xb 0

tRCmin

tRAS

PRE

tRP

1

ACT

Xb

Xb

A11

Xa

Xb

Xb

BA0,1

00

01 00

01

DQ

Qa0 Qa1 Qa2 Qa3

READ

Precharge all

After tRCD from the bank activation, a READ command can be issued. 1st output data is

available after the /CAS Latency from the READ, followed by (BL -1) consecutive data when the

Burst Length is BL. The start address is specified by A0-A9,A11(x4), A0-9(X8), A0-8(X16) , and

the address sequence of burst data is defined by the Burst Type. A READ command may be applied

to any active bank, so the row precharge time (tRP) can be hidden behind continuous output data by

interleaving the multiple banks. When A10 is high at a READ command, the auto-precharge

(READA) is performed. Any command (READ, WRITE, PRE, ACT) to the same bank is inhibited

till the internal precharge is complete. The internal precharge starts at BL after READA. (Need to

keep tRAS min.) The next ACT command can be issued after (BL + tRP) from the previous READA.

MITSUBISHI ELECTRIC

18

Share Link: