LPC4357FET256 View Datasheet(PDF) - NXP Semiconductors.
Part Name
Description
Manufacturer
LPC4357FET256
NXP Semiconductors.
LPC4357FET256 Datasheet PDF : 162 Pages
| |||
NXP Semiconductors
Table 3. Pin description …continued
Pin name
LPC435x/3x/2x/1x
32-bit ARM Cortex-M4/M0 microcontroller
Description
P1_5
P1_6
P1_7
R5 J4
65 48 [2]
N; I/O GPIO1[8] — General purpose digital input/output pin.
PU O CTOUT_10 — SCT output 10. Match output 3 of timer 3.
- R — Function reserved.
O EMC_CS0 — LOW active Chip Select 0 signal.
I USB0_PWR_FAULT — Port power fault signal indicating
overcurrent condition; this signal monitors over-current on
the USB bus (external circuitry required to detect
over-current condition).
I/O SSP1_SSEL — Slave Select for SSP1.
I/O SGPIO15 — General purpose digital input/output pin.
O SD_POW — SD/MMC power monitor output.
T4 K4 67 49 [2] N; I/O GPIO1[9] — General purpose digital input/output pin.
PU I CTIN_5 — SCT input 5. Capture input 2 of timer 2.
- R — Function reserved.
O EMC_WE — LOW active Write Enable signal.
- R — Function reserved.
O EMC_BLS0 — LOW active Byte Lane select signal 0.
I/O SGPIO14 — General purpose digital input/output pin.
I/O SD_CMD — SD/MMC command signal.
T5 G4 69 50 [2] N; I/O GPIO1[0] — General purpose digital input/output pin.
PU I U1_DSR — Data Set Ready input for UART1.
O CTOUT_13 — SCT output 13. Match output 3 of timer 3.
I/O EMC_D0 — External memory data line 0.
O USB0_PPWR — VBUS drive signal (towards external
charge pump or power management unit); indicates that
VBUS must be driven (active HIGH).
Add a pull-down resistor to disable the power switch at reset.
This signal has opposite polarity compared to the
USB_PPWR used on other NXP LPC parts.
- R — Function reserved.
- R — Function reserved.
- R — Function reserved.
LPC435X_3X_2X_1X
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 5.2 — 26 November 2015
© NXP Semiconductors N.V. 2015. All rights reserved.
12 of 162
Share Link: