S25FL127SABMFI003 View Datasheet(PDF) - Cypress Semiconductor
Part Name
Description
Manufacturer
S25FL127SABMFI003 Datasheet PDF : 142 Pages
| |||
S25FL127S
Hardware Interface
Serial Peripheral Interface with Multiple Input / Output (SPI-MIO)
Many memory devices connect to their host system with separate parallel control, address, and data signals that require a large
number of signal connections and larger package size. The large number of connections increase power consumption due to so
many signals switching and the larger package increases cost.
The S25FL-S family of devices reduces the number of signals for connection to the host system by serially transferring all control,
address, and data information over 4 to 6 signals. This reduces the cost of the memory package, reduces signal switching power,
and either reduces the host connection count or frees host connectors for use in providing other features.
The S25FL-S family of devices uses the industry standard single bit Serial Peripheral Interface (SPI) and also supports optional
extension commands for two bit (Dual) and four bit (Quad) wide serial transfers. This multiple width interface is called SPI Multi-I/O
or SPI-MIO.
2. Signal Descriptions
2.1 Input/Output Summary
Table 2. Signal List
Signal Name
Type
RESET#
Input
SCK
CS#
SI / IO0
SO / IO1
Input
Input
I/O
I/O
WP# / IO2
I/O
HOLD# / IO3
or IO3 /
RESET#
VCC
VSS
I/O
Supply
Supply
NC
Unused
RFU
Reserved
DNU
Reserved
Description
Hardware Reset. The signal has an internal pull-up resistor and should be left unconnected in
the host system if not used.
Serial Clock.
Chip Select.
Serial Input for single bit data commands or IO0 for Dual or Quad commands.
Serial Output for single bit data commands. IO1 for Dual or Quad commands.
Write Protect when not in Quad mode. IO2 in Quad mode. The signal has an internal pull-up
resistor and may be left unconnected in the host system if not used for Quad commands.
Hold (pause) serial transfer in single bit or Dual data commands. IO3 in Quad-I/O mode.
RESET# when enabled by SR2[5]=1 and not in Quad-I/O mode, CR1[1]=0. or when CS# is high.
The signal has an internal pull-up resistor and may be left unconnected in the host system if not
used for Quad commands.
Power Supply.
Ground.
Not Connected. No device internal signal is connected to the package connector nor is there
any future plan to use the connector for a signal. The connection may safely be used for routing
space for a signal on a Printed Circuit Board (PCB). However, any signal connected to an NC
must not have voltage levels higher than VCC.
Reserved for Future Use. No device internal signal is currently connected to the package
connector but there is potential future use of the connector for a signal. It is recommended to not
use RFU connectors for PCB routing channels so that the PCB may take advantage of future
enhanced features in compatible footprint devices.
Do Not Use. A device internal signal may be connected to the package connector. The
connection may be used by Cypress for test or other purposes and is not intended for connection
to any host system signal. Any DNU signal related function will be inactive when the signal is at
VIL. The signal has an internal pull-down resistor and may be left unconnected in the host system
or may be tied to VSS. Do not use these connections for PCB signal routing channels. Do not
connect any host system signal to this connection.
Document Number: 001-98282 Rev. *I
Page 9 of 142
Share Link: 