DSP56011 View Datasheet(PDF) - Motorola => Freescale
Part Name
Description
Manufacturer
DSP56011 Datasheet PDF : 82 Pages
| |||
Signal/Connection Descriptions
Serial Audio Interface (SAI)
SERIAL AUDIO INTERFACE (SAI)
The SAI is composed of separate receiver and transmitter sections.
P R E L I M I N A R Y SAI Receive Section
The receive section of the SAI has four dedicated signals.
Table 1-8 Serial Audio Interface (SAI) Receive Signals
Signal
Name
Signal
Type
State
during
Reset
Signal Description
SDI0
SDI1
SCKR
Input
Tri-
stated
Input
Tri-
stated
Input or Tri-
Output stated
Serial Data Input 0—This is the receiver 0 serial data input.
This signal is high impedance during hardware or software
reset, while receiver 0 is disabled (R0EN = 0), or while the chip
is in the Stop state. No external pull-up resistor is required.
Serial Data Input 1—This is the receiver 1 serial data input.
This signal is high impedance during hardware or software
reset, while receiver 1 is disabled (R1EN = 0), or while the chip
is in the Stop state. No external pull-up resistor is required.
Receive Serial Clock—SCKR is an output if the receiver
section is programmed as a master, and a Schmitt-trigger
input if programmed as a slave.
WSR
Input or Tri-
Output stated
SCKR is high impedance if all receivers are disabled (personal
reset) and during hardware or software reset, or while the chip
is in the Stop state. No external pull-up is necessary.
Receive Word Select—WSR is an output if the receiver section
is programmed as a master, and a Schmitt-trigger input if
programmed as a slave. WSR is used to synchronize the data
word and to select the left/right portion of the data sample.
WSR is high impedance if all receivers are disabled (personal
reset), during hardware reset, during software reset, or while
the chip is in the stop state. No external pull-up is necessary.
MOTOROLA
Preliminary Information
DSP56011 Technical Data Sheet, Rev. 1
1-15
Share Link: 